|
|
|
| The Analysis on a Burst Fault of Double Umbrella Type Porcelain Insulators on a 220kV Overhead Transmission Line |
| Xia Lingzhi1, Cheng Dengfeng1, Qin Jinfei1, Li Senlin1, Ji Kun2 |
1. State Grid Anhui Electric Power Research Institute, Hefei 230022;
2. Sate Grid Anhui Electric Power Company, Hefei 230061 |
|
|
|
|
Abstract String the burst fault of double umbrella type porcelain insulators on a 220kV overhead transmission line, defective batch insulators were extracted for test analysis. The main test items included temperature cycle test, power frequency breakdown test, electromechanical failing load test and porosity test. The results showed that there were two electromechanical failing load tests in the three samples. The measured damage values of the electromechanical failure were much lower than the rated value. The failure modes were porcelain faults, indicating that there were problems with the quality of the insulator. It was recommended to replace the batch insulators, and strengthen the porcelain insulator testing in network, construction acceptance. The zero value detection work should be regularly carried out, and the low value and zero value insulators should be timely replaced.
|
|
Published: 20 September 2017
|
|
|
|
| Cite this article: |
|
Xia Lingzhi,Cheng Dengfeng,Qin Jinfei等. The Analysis on a Burst Fault of Double Umbrella Type Porcelain Insulators on a 220kV Overhead Transmission Line[J]. Electrical Engineering, 2017, 18(9): 72-74.
|
|
|
|
| URL: |
|
http://dqjs.cesmedia.cn/EN/Y2017/V18/I9/72
|
[1] 李翔, 顾洪连. 三种绝缘子可靠性的比较[J]. 高电压技术, 2007, 33(5): 191-193.
[2] 肖雷, 施景垒, 陈平春, 等. 双伞瓷绝缘子故障试验分析[J]. 江苏电机工程, 2015, 34(1): 15-17.
[3] 张秀斌, 彭鹏, 温定筠, 等. 一起330kV悬式绝缘子炸裂故障分析[J]. 电气技术, 2017, 18(1): 129-132.
[4] 罗凌, 张福增, 李锐海, 等. 抑制运行V串直流瓷绝缘子铁帽电解腐蚀的马蹄形锌环设计[J]. 电工技术学报, 2015, 30(2): 220-228.
[5] 罗凌, 张福增, 王黎明, 等. 高压直流瓷和玻璃绝缘子金属附件电解腐蚀试验方法[J]. 电工技术学报, 2015, 30(9): 103-111.
[6] 邱志斌, 阮江军, 黄道春, 等. 输电线路悬式瓷绝缘子老化形式分析与试验研究[J]. 高电压技术, 2016, 42(4): 1259-1267.
[7] 王少敏, 魏刚, 王莉. 瓷绝缘子劣化应对措施探讨[J]. 电瓷避雷器, 2006(5): 6-8, 13.
[8] 标称电压高于1000V的架空线路绝缘子 第1部分: 交流系统用瓷或玻璃绝缘子元件——定义、试验方法和判定准则: GB/T 1001.1—2003[S]. 北京: 中国标准出版社, 2003.
[9] DL/T 626—2015 劣化悬式绝缘子检测规程[S]. 北京: 中国电力出版社, 2015.
[10] 王兴照, 周大洲, 王宁. 基于热红外成像技术的绝缘子故障分类研究[J]. 电气技术, 2016, 17(11): 140-142, 150.
[11] 赵江辉, 岳红利. 一种瓷质绝缘子故障状态判定方法介绍[J]. 电气技术, 2017, 18(1): 120-122. |
|
|
|
2017, Vol. 18 
