无功功率补偿柜动态响应检测方法介绍与分析

摘要
图/表
参考文献
相关文章 (15)

全文: PDF (422 KB) HTML (1 KB)
输出: BibTeX | EndNote (RIS)

摘要本文主要根据标准GB/T5576-2008低压成套无功功率补偿装置,介绍了动态响应时间检测项目试验方法与原理。并对在试验过程中可能发生补偿不到位等故障进行分析介绍。利用茹科夫线圈采集补偿电流波形时间参数,以及利用SP控制器控制配电线路负载端导通时间与停止。通过分析介绍,可以提高在检测此项目的试验效率。

	服务

	把本文推荐给朋友
	加入我的书架
	加入引用管理器
	E-mail Alert
	RSS
	作者相关文章
	张业真

关键词 ：低压无功功率补偿, 动态响应时间, 波形, SP控制器

Abstract：mainly according to the standard of GB/T5576-2008 low voltage complete sets of reactive power compensate device, this article introduces the test method and principle of dynamic response time detection project. It introduces and analyses the failure which would happen in the test process, such as compensation does not reach the design value. Making the Use of shavings cove coil to gather the time parameter of compensated current waveform, and making the use of SP controller to control the conduction time and stop of distribution line load end. Through the analysis of introduction, we can improve the test efficiency of this project detection.

Key words： low voltage reactive power compensation dynamic response time. waveform SP controller

出版日期: 2013-10-10

作者简介: 张业真, 福建省产品质量检验研究院, 助理工程师, 检验员。

引用本文:

张业真. 无功功率补偿柜动态响应检测方法介绍与分析[J]. 电气技术, 2013, 14(09): 77-79. Zhang Yezhen. Introduction and Analysis of the Dynamic Response Testing Method of Reactive Power Compensation Ark. Electrical Engineering, 2013, 14(09): 77-79.

链接本文:

https://dqjs.cesmedia.cn/CN/Y2013/V14/I09/77