安装环境温湿度影响下气体绝缘金属封闭开关设备水分含量研究

摘要
图/表
参考文献
相关文章 (3)

全文: PDF (9207 KB) HTML (1 KB)
输出: BibTeX | EndNote (RIS)

摘要针对气体绝缘金属封闭开关设备（GIS）在安装时受环境温湿度的影响,导致安装完成后气室剩余水分含量过高而需要重新安装的问题,本文提出一种考虑安装环境因素的GIS剩余水分含量计算方法。首先制定GIS安装流程,其次对气室密封后总水分量进行计算,最后按所制定的安装流程计算出平衡后SF₆中水分含量。仿真和试验结果表明,气室内SF₆中水分含量随安装环境温度及相对湿度的增加而增加,计算值随安装环境温湿度的变化趋势与试验值较吻合,且相对误差小于15%,可较好地预测安装环境温湿度影响下的GIS剩余水分含量变化,有利于工程中选择合适的安装环境。

	服务

	把本文推荐给朋友
	加入我的书架
	加入引用管理器
	E-mail Alert
	RSS
	作者相关文章
	张少乾
	卞宏志
	张建勋
	黄宴委

关键词 ：气体绝缘金属封闭开关设备（GIS）, 安装环境, 温湿度, 水分含量, 计算模型

Abstract：Aiming at the problem that gas insulated switchgear (GIS) is affected by environmental temperature and humidity during installation, which leads to high residual moisture content of gas chamber after installation and needs to be re-installed, a calculation method of residual moisture content of GIS gas chamber considering installation environmental factors is proposed. Firstly, the GIS installation process is formulated. Secondly, the total moisture component of the gas chamber after sealing is calculated. Finally, the moisture content of the balanced SF₆ is calculated according to the installation process. The simulation and experimental results show that the moisture content of SF₆ in the gas chamber increases with the increase of installation environment temperature and relative humidity. The calculated value is in good agreement with the experimental value with the increase of installation environment temperature and humidity, and the relative error is less than 15%. It can better predict the change of GIS residual moisture content under the influence of installation environment temperature and humidity, which is conducive to the selection of suitable installation environment in engineering.

Key words： gas insulated switchgear (GIS) installation environment temperature and humidity moisture content computational model

收稿日期: 2021-07-13

作者简介: 张少乾（1994—）,男,河北省邯郸市人,硕士研究生,主要从事电气工程智能化技术研究工作。

引用本文:

张少乾, 卞宏志, 张建勋, 黄宴委. 安装环境温湿度影响下气体绝缘金属封闭开关设备水分含量研究[J]. 电气技术, 2022, 23(1): 15-20. ZHANG Shaoqian, BIAN Hongzhi, ZHANG Jianxun, HUANG Yanwei. Research on moisture content of gas insulated switchgear under the influence of installation environment temperature and humidity. Electrical Engineering, 2022, 23(1): 15-20.

链接本文:

http://dqjs.cesmedia.cn/CN/Y2022/V23/I1/15

[1] 刘丹. 500kV气体绝缘金属封闭开关设备改造案例介绍[J]. 电气技术, 2020, 21(1): 54-59.
[2] 纽春萍, 矫璐璐, 王小华, 等. 基于多场耦合的环保型GIS热特性分析[J]. 电工技术学报, 2020, 35(17): 3765-3772.
[3] 梁启鸿. 220kV全封闭组合电器(GIS)微水分析及处理探讨[J]. 技术与市场, 2016, 23(7): 74-75.
[4] 周朕蕊, 韩冬, 赵明月, 等. SF₆替代气体分解特性的研究综述[J]. 电工技术学报, 2020, 35(23): 4998-5014.
[5] 赵强, 曹力雄. 一起特高压换流站500kV断路器击穿故障分析与处理[J]. 电气技术, 2021, 22(8): 58-61.
[6] KOCHSIEK M.Measurement of water adsorption layers on metal surfaces[J]. Metrologia, 1982, 18(3): 153-158.
[7] OHMI T, NAKAGAWA Y, AOMI H, et al.New technique for the measurement of adsorbed moisture concentration on a solid surface[J]. Review of Scientific Instruments, 1993, 64(9): 2683-2686.
[8] LUTZ B, KINDERSBERGER J.Influence of absorbed water on volume resistivity of epoxy resin insu- lators[C]//10th IEEE International Conference on Solid Dielectrics, Potsdam, Germany, 2010: 1-4.
[9] 工业六氟化硫: GB/T 12022—2014[S] GB/T 12022—2014[S]. 北京: 中国标准出版社, 2014.
[10] 郑晓光, 郑宇, 唐念, 等. GIS内环氧树脂绝缘沿面放电强度与产气关联规律的模拟实验[J]. 电工技术学报, 2015, 30(17): 172-179.
[11] 王永翔, 黄根, 肖敏, 等. 特高压换流站GIS安装过程中的问题研究[J]. 电气技术, 2018, 19(5): 102-104.
[12] 刘大震, 罗敏. 理想气体状态方程在GIS检修中的应用研究[J]. 工程技术, 2019(2): 97-98.
[13] IEEE guide for moisture measurement and control in SF₆ gas-insulated equipment: IEEE C37.122.5— 2013[S]. US: IEEE, 2013.
[14] 陈晓丽, 周顺期. 密封包装容器内湿度变化规律研究[J]. 包装工程, 2004, 25(6): 21-23.
[15] 张茜, 苑中显, 王文超, 等. SAPO-34分子筛的动态吸附特性实验研究[J]. 低温与超导, 2016, 44(9): 78-84.
[16] 苑金海, 杨芳, 曹胜利. 高压SF₆断路器吸附剂用量的计算[J]. 电气制造, 2007, 3(9): 78-80.
[17] 崔云鹏. 分子筛/水体系的吸附脱附量平衡性质的研究[J]. 天然气化工, 2001, 26(3): 11-14.
[18] 张秀娟, 刘勇. SF₆电器中气体水分含量的危害及控制措施[J]. 冶金动力, 2013, 5(4): 16-17.
[19] 陈敏, 姚唯建. 六氟化硫互感器湿度超标原因分析与处理[J]. 广州化工, 2014, 42(9): 142-143.
[20] 陈振生. GIS高压电器SF₆气体密度、湿度及泄漏检测技术[J]. 电气技术, 2007, 8(4): 16-20.