|
|
|
| Generation mechanism of power cable grounding wire frequency current and its influence on relay |
| Yang Yuanhang, Shi Hengchu, Chen Jianping, Shi Chao, Yang Zaihe |
| Yunnan Power Dispatching Control Center, Kunming 650000 |
|
|
|
|
Abstract The research on the generation mechanism of power cable grounding wire frequency current and the influence on protection are not clear. This paper studies the causes and characteristics of power frequency current of grounding wire, points out that the current mainly consists of the induced current which induced by the zero sequence current and the distributed current which generated by the injected current of the grounding grid. The mutual inductance circuit model of cable line and ground loop is established to describe the quantitative relation between the zero sequence current of cable and the induced current of grounding wire. Also, this paper points out that the distribution current of grounding wire depends on the topology of grounding grid and the position of current injection point, and the maximum current can be half of the injected current. Then this paper analyzes the influence of the current on the zero sequence current measurement and points out the reasons for the abnormal action of zero sequence protection and small current grounding fault selection. At last, the correctness of the above conclusion is verified by an example of zero sequence protection rejection in a wind farm.
|
|
Received: 03 February 2018
Published: 23 October 2018
|
|
|
|
| Cite this article: |
|
Yang Yuanhang,Shi Hengchu,Chen Jianping等. Generation mechanism of power cable grounding wire frequency current and its influence on relay[J]. Electrical Engineering, 2018, 19(10): 50-54.
|
|
|
|
| URL: |
|
http://dqjs.cesmedia.cn/EN/Y2018/V19/I10/50
|
[1] 陈冬霞. 10kV零序电流互感器特性及其检测方法研究[D]. 广州: 华南理工大学, 2014.
[2] 贾清泉, 王振宇, 王宁, 等. 基于参数辨识的消弧线圈接地电网单相接地故障测距方法[J]. 电工技术学报, 2016, 31(23): 77-85.
[3] 汤涛, 黄纯, 江亚群, 等. 基于馈线零序阻抗特性的谐振接地故障选线方法[J]. 电工技术学报, 2016, 31(20): 192-201.
[4] 张保会, 尹项根. 电力系统继电保护[M]. 北京: 中国电力出版社, 2005.
[5] 汤涛, 黄纯, 江亚群, 等. 基于馈线零序阻抗特性的谐振接地故障选线方法[J]. 电工技术学报, 2016, 31(20): 192-201.
[6] 姜健, 鲍光海. 小电流接地系统单相接地故障选线方法综述[J]. 电气技术, 2015, 16(12): 1-5.
[7] GB 50168—2006. 电气装置安装工程电缆线路施工及验收规范[S].
[8] 单国栋. 零序电流互感器安装工艺引起的保护拒动分析[J]. 电气技术, 2017, 18(9): 85-88.
[9] 李维, 闫蓉. 钢铠电缆接地零序保护拒动原因分析[J]. 内蒙古科技与经济, 2013(12): 104-105.
[10] 武琼, 曹永进, 唐其筠, 等. 配网小电阻接地改造二次常见问题分析[J]. 电气技术, 2016, 17(8): 126-129.
[11] 郭法安. 中压配电网三芯电缆接地电流的机理与应用[D]. 济南: 山东大学, 2016.
[12] 李维, 闫蓉. 钢铠电缆接地零序保护拒动原因分析[J]. 内蒙古科技与经济, 2013(12): 104-105.
[13] 王娟. 厂用6kV系统零序保护误动及二次接线分析[J]. 机电信息, 2013(6): 7-8.
[14] 马文蔚. 物理学[M]. 北京: 高等教育出版社, 2006.
[15] 何仰赞, 温增银. 电力系统分析[M]. 武汉: 华中科技大学出版社, 2002. |
|
|
|
2018, Vol. 19 
