研究与开发
|
基于最大电压偏差裕度的MMC子模块均压优化算法研究
曾欢, 李锐华, 胡波, 胡浩
同济大学电气工程系,上海 201804
The Research of Optimized Capacitor Voltage Balancing Algorithm of MMC based on Maximum Voltage Deviation Margin
Zeng Huan, Li Ruihua, Hu Bo, Hu Hao
Electrical Engineering of Tongji University, Shanghai 201804
摘要 根据模块化多电平换流器(MMC)的运行原理,针对传统子模块电容电压排序算法存在器件开关频率高、从而引起开关损耗较大的问题,本文提出一种基于最大电压偏差裕度的均压优化算法。该算法考虑了子模块上一时刻开关投切状态以及各子模块电压之间的差值,可以在保证各子模块电容电压基本一致的前提下,避免IGBT不必要的反复投切,有效降低MMC子模块开关频率,减小开关损耗,从而提高系统运行效率。本文通过在Matlab/Simulink平台上搭建21电平的MMC仿真模型进行了仿真,仿真结果验证了均压优化算法的正确性和有效性。
关键词 :
模块化多电平换流器 ,
排序均压算法 ,
开关频率 ,
最大电压偏差裕度
Abstract :The traditional capacitor voltage balancing arithmetic results in high switching frequency and high switching losses. In order to solve this problem, this paper studies the operating principle of modular multilevel converter (MMC) and proposes an optimized capacitor voltage balancing algorithm based on maximum voltage deviation margin. This is done by considering the switching status and voltage deviation of submodules, which can reduce the switching frequency of IGBT under satisfying the balance demand, thus reducing switching losses and improving the efficiency of the system. At last, the simulation based on a 21-level three-phase MMC in Matlab/Simulink verifies the validity and effectiveness of the proposed algorithm.
Key words :
MMC
capacitor voltage balancing arithmetic
switching frequency
voltage deviation
出版日期: 2017-09-20
作者简介 : 曾 欢(1994-),男,江西吉安人,同济大学在读硕士研究生,主要研究方向为电力电子技术。
引用本文:
曾欢, 李锐华, 胡波, 胡浩. 基于最大电压偏差裕度的MMC子模块均压优化算法研究[J]. 电气技术, 2017, 18(9): 4-9.
Zeng Huan, Li Ruihua, Hu Bo, Hu Hao. The Research of Optimized Capacitor Voltage Balancing Algorithm of MMC based on Maximum Voltage Deviation Margin. Electrical Engineering, 2017, 18(9): 4-9.
链接本文:
https://dqjs.cesmedia.cn/CN/Y2017/V18/I9/4
[1] Lesnicar A, Marquardt R. An innovative modular multilevel converter topology suitable for a wide power range[C]//Power Tech Conference Proceedings, 2003 IEEE Bologna. IEEE, 2003(3): 6. [2] 康伟, 龙云波, 宗波, 等. 集成化的模块化多电平换流器功率模块设计与研制[J]. 电气技术, 2015, 16(2): 17-22. [3] 佚名. 基于双电容模块的MMC型多端口电力电子变压器[J]. 电气技术, 2016, 17(8): 81-81. [4] 杨晓峰, 林智钦, 郑琼林, 等. 模块组合多电平变换器的研究综述[J]. 中国电机工程学报, 2013, 33(6): 1-14, 前插1. [5] 张建坡, 赵成勇, 孙海峰, 等. 模块化多电平换流器改进拓扑结构及其应用[J]. 电工技术学报, 2014, 29(8): 173-179. [6] 黄守道, 廖武, 高剑, 等. 基于改进均压算法的模块化多电平变流器开关频率分析[J]. 电工技术学报, 2016, 31(13): 36-45. [7] Debnath S, Qin Jiangchao, Bahrani B, et al. Operation, control, and applications of the modular multilevel converter: a review[J]. IEEE Transactions on Power Electronics, 2015, 30(1, SI): 37-53. [8] 管敏渊, 徐政. MMC型VSC-HVDC系统电容电压的优化平衡控制[J]. 中国电机工程学报, 2011, 31(12): 9-14. [9] 郭裕群, 赵成勇, 许建中, 等. 模块化多电平换流器子模块平均开关频率的精确控制方法[J]. 电力系统自动化, 2016, 40(19): 94-100. [10] 何志兴, 罗安, 熊桥坡, 等. 模块化多电平变换器模型预测控制[J]. 中国电机工程学报, 2016, 36(5): 1366-1375. [11] Qin Jiangchao, Saeedifard M. Reduced switching- frequency voltage-balancing strategies for modular multilevel HVDC converters[J]. IEEE Transactions on Power Delivery, 2013, 28(4): 2403-2410. [12] 丁冠军, 丁明, 汤广福, 等. 新型多电平VSC子模块电容参数与均压策略[J]. 中国电机工程学报, 2009(30): 1-6. [13] Jia X, Liu J, Zhang J. The research of capacitor voltage balancing strategy of MMC[C]//International Con- ference on Civil, Materials and Environmental Sciences, 2015. [14] 郭高朋, 姚良忠, 温家良. 模块化多电平变流器的子模块分组调制及均压控制[J]. 中国电机工程学报, 2016, 36(1): 145-153. [15] Tu Qingrui, Zheng Xu, Xu Lie. Reduced Switching- Frequency modulation and circulating current suppression for modular multilevel converters[J]. Power Delivery, IEEE Transactions on, 2011, 26(3): 2009-2017. [16] Chai R Z, Zhang B H, Hao Z G, et al. A low switching frequency voltage balancing strategy of modular multilevel converter[C]//on 2013-2013, 2013: 1-4.
[1]
周谷庆, 仲浩, 赵玉灿, 赵天恩. 模块化多电平换流器阀控装置录波功能研究 [J]. 电气技术, 2024, 25(1): 79-84.
[2]
李志川, 兰生, 魏柯. 基于MRSVD-GRU的混合三端特高压直流输电线路单极接地故障定位方法 [J]. 电气技术, 2023, 24(3): 1-8.
[3]
魏银图, 张旸, 温步瀛, 王怀远. 基于支持向量机的模块化多电平换流器子模块开路故障诊断方法 [J]. 电气技术, 2023, 24(10): 1-7.
[4]
陈明泉, 肖世挺, 严昌华, 施清山, 吴金福. 厦门柔直工程高频谐波保护方案分析与试验 [J]. 电气技术, 2023, 24(10): 79-84.
[5]
常昊添, 李建春, 赵文强, 侍乔明. 基于动模仿真的混合级联直流输电系统控制策略 [J]. 电气技术, 2023, 24(1): 50-59.
[6]
许嘉杰, 李锐华, 胡波. 基于三矢量模型预测控制的T型三电平整流器定频控制策略 [J]. 电气技术, 2022, 23(6): 17-23.
[7]
邹毅军, 魏明洋. 模块化多电平换流器子模块故障模拟方法 [J]. 电气技术, 2022, 23(4): 96-101.
[8]
班国邦, 牛唯, 杨文勇, 李建文, 李戎. 基于模块化多电平换流器的直流融冰装置馈线潮流控制仿真 [J]. 电气技术, 2021, 22(9): 27-33.
[9]
苏嘉彬, 陈斌, 熊静, 周亚龙, 羌丁建. 基于模块化多电平换流器的背靠背柔性直流换流站绝缘配合方案研究 [J]. 电气技术, 2020, 21(5): 84-89.
[10]
王婷, 杨明发. 基于改进型模块化嵌入式多电平换流器拓扑的HVDC直流故障清除策略 [J]. 电气技术, 2020, 21(12): 17-22.
[11]
周海鸿, 杨明发, 阮俊峰. MMC-HVDC输电系统直流故障隔离综述 [J]. 电气技术, 2019, 20(1): 1-6.
[12]
唐志军. 柔性直流输电工程起动策略及时间定值整定 [J]. 电气技术, 2018, 19(4): 63-66.
[13]
邹焕雄, 李超, 胡文旺, 晁武杰. 厦门柔性直流输电工程真双极大功率试验方法研究 [J]. 电气技术, 2017, 18(6): 23-26.
[14]
谢志德, 杨明发. 基于混合旁路MMC-HVDC直流故障隔离技术研究 [J]. 电气技术, 2017, 18(11): 39-43.
[15]
康伟,龙云波,宗波,徐云飞. 集成化的模块化多电平换流器功率模计与研制 [J]. 电气技术, 2015, 16(02): 17-22.