制约葛南直流大负荷精准控制的关键因素

Abstract
Figure/Table
References
Related Citation (15)

Download: PDF (815 KB) HTML (1 KB)
Export: BibTeX | EndNote (RIS)

Abstract In 2023, Ge-Nan DC project carried out the renovation of control, protection and converter valves. During the trial operation, there was an abnormal situation where the power did not reach 1 160MW due to overload limiting current. Therefore, the reason why the DC voltage at the sending end cannot reach the rated voltage during high load operation after the renovation of DC line is analyzed firstly. On this basis, the key factors restricting accurate control of high load are analyzed, including low AC voltage or low converter gear, higher relative DC inductive voltage drop set in the control than the actual value, and extinction angle operating above the rated reference value. Subsequently, a brief analysis is conducted on the impact of measurement error of DC voltage, deviation of DC line resistance and forward pressure drop of converter valve on accurate control of DC power. Finally, targeted solutions are proposed and validated through the real-time digital simulation platform.

Key words： DC transmission accurate control overload limitation high load line renovation

Received: 13 November 2023

	Service

	E-mail this article
	Add to my bookshelf
	Add to citation manager
	E-mail Alert
	RSS
	Articles by authors
	FU Guangxu
	WANG Yongping
	LUO Jinhui

Cite this article:

FU Guangxu,WANG Yongping,LUO Jinhui. Key factors restricting accurate control of high load in Ge-Nan direct current project[J]. Electrical Engineering, 2024, 25(2): 79-84.

URL:

http://dqjs.cesmedia.cn/EN/Y2024/V25/I2/79

[1] 陈宗器. 中国发展直流输电工程的历程[J]. 电气技术, 2007, 8(12): 72-75.
[2] 曾南超, 陶瑜. 葛上直流输电工程的系统研究及调试[J]. 电网技术, 1991, 15(3): 65-69, 108.
[3] 林森. 葛南直流控制保护系统改造工程顺利完成[J].华东电力, 2005, 33(5): 33.
[4] 井然. 我国直流输电设备国产化获重大进展[N]. 中国电力报, 2005-08-11(5).
[5] 刘臣宾, 卢宇, 邵震霞, 等. ±500kV葛南与荆沪同塔双回直流系统特性仿真研究[J]. 江苏电机工程, 2011, 30(4): 1-4.
[6] 李新年, 吕鹏飞, 杨鹏, 等. 同塔架设直流线路的相互影响研究[J]. 电网技术, 2012, 36(11): 222-228.
[7] 江德明, 梅筠颋, 韩雅帅. 直流运行方式改变导致热备用状态线路跳闸原因分析[J]. 电世界, 2021, 62(9): 1-7.
[8] 沈天骄, 仲浩, 王永平, 等. 自主可控特高压直流控制保护系统设计与研发[J]. 电气技术, 2022, 23(3): 50-56.
[9] 李林, 王永平, 黄志岭, 等. 三峡-常州±500kV直流输电工程控制保护系统改造[J]. 电气技术, 2022, 23(12): 38-43, 51.
[10] 游逍遥, 刘和平, 苗轶如, 等. 带恒功率负载的双极性直流系统稳定性分析及其有源阻尼方法[J]. 电工技术学报, 2022, 37(4): 918-930.
[11] 卢东斌, 王永平, 王振曦, 等. 分层接入方式的特高压直流输电逆变侧最大触发延迟角控制[J]. 中国电机工程学报, 2016, 36(7): 1808-1816.
[12] 刘学智, 张沛超, 严正. 第5代区域供热供冷驱动的产消型综合能源系统多能流分析[J]. 电力系统自动化, 2023, 47(4): 78-90.
[13] 陈华山. 换相电抗的测量与计算[J]. 变压器, 1997, 34(3): 23-24.
[14] 黄天超, 王泽忠, 李宇妍. 换流变压器直流偏磁对油箱涡流损耗的影响[J]. 电工技术学报, 2023, 38(8): 2004-2014.
[15] 刘一萌. 变压器绕组线圈变形故障分析[D]. 天津: 天津工业大学, 2020.